Evans Cooling System Flush ½ Gallon Bottle

$26.95
SKU
EVANS-E2012

Evans - Cooling System Flush. Sku: EVANS-E2012, P/n: E2012

Evans

Cooling System Flush

Manufacturer: Evans

Part Number: E2012


Usage
Evans, E2012

  Determine cooling system capacity (refer to owner's manual).

  When engine is cool, remove cap, open draincock and drain cooling system (remove block drains if applicable). Collect used antifreeze for disposal. When disposing used antifreeze/flush, please follow local laws and regulations.

  Flush with water until water runs clear.

  Close all drains.

  Install flush (refer to chart).

  Once the appropriate amount of flush is installed into the radiator, fill system with water.

  Place heater on highest setting.

  Drive vehicle for 2 hours at normal temperature. DO NOT let sit idling, MUST drive!

  Allow engine to cool to room temperature. NEVER WORK on a HOT system!

  Drain system. * * Remove block drains if applicable, drain radiator and heater core.

  Flush with water until it runs clear. This will neutralize the flush.

  Start the installation process to convert to Evans Waterless Coolant by following the standard Evans installations.


Video
Evans, E2012

More Information
Alternative Part Number 1 - None -
Alternative Part Number 2 - None -
Alternative Part Number 3 - None -
Alternative Part Number 4 - None -
Alternative Part Number 5 - None -
Alternative Part Number 6 - None -
Alternative Part Number 7 - None -
Write Your Own Review
You're reviewing:Evans Cooling System Flush ½ Gallon Bottle
To Top